X9 Owners Club Gallery

Scooter related interest

Top rated
headlight_switch.jpg
headlight_switch.jpg446 views55555
(3 votes)
pict0032.jpg
pict0032.jpgClean the debris out of the front filter gauze307 views55555
(2 votes)
switch.JPG
switch.JPG635 views55555
(2 votes)
DCP01459.JPG
DCP01459.JPGRubber bungs939 viewsRemove with a blunt screwdriver.55555
(2 votes)
IMG_20190227_141756478.jpg
IMG_20190227_141756478.jpg60 views55555
(1 votes)
DSC_0482.JPG
DSC_0482.JPG72 views55555
(1 votes)
250lights.jpg
250lights.jpgX9 250 evo lighting circuit278 viewsExtract from workshop manual55555
(1 votes)
PICT0008.JPG
PICT0008.JPG71 views55555
(1 votes)
P6290002.jpg
P6290002.jpgPhoto opportunity108 views55555
(1 votes)
DSCF0061.JPG
DSCF0061.JPGPut all the panels back on158 viewsJob complete. Now test run just to make sure everything is OK.55555
(1 votes)
DSCF0052.JPG
DSCF0052.JPGRefit the two washers and rear hub nut123 viewsNip up the nut while holding the rear brake on.55555
(1 votes)
DSCF0049.JPG
DSCF0049.JPGStart the engine126 viewsRun for only a few seconds just to settle the belt into the normal tension.55555
(1 votes)
DSCF0048.JPG
DSCF0048.JPGRefit the damper pulley128 viewsLightly grease the pivot bolt and refit the pulley noting that it is the correct way around.55555
(1 votes)
DSCF0044~0.JPG
DSCF0044~0.JPGCheck the belt179 viewsMake sure the belt is not nipped by the pulley halves and that the torque on the nut is fully used to force the outer pulley onto the spacer tube and washer.55555
(1 votes)
DSCF0041~2.JPG
DSCF0041~2.JPGFront fastenings153 viewsSlide on the two washers making sure the convex one is the right way round55555
(1 votes)
DSCF0036~0.JPG
DSCF0036~0.JPGRear pulley needle bearings316 viewsApply some LM grease to the inner bearings of the rear pulley. Not too much but enough to fill the cavity inside the sleeve.55555
(1 votes)
DSCF0035~0.JPG
DSCF0035~0.JPGSlide on the spacer121 viewsSometimes called the 'fuzzy washer' and a thicker one lowers the gearing. Never try leaving it off or the outer pulley gets stuck solid on the shaft.55555
(1 votes)
DSCF0034~0.JPG
DSCF0034~0.JPGSPacer Tube115 viewsSlide the spacer tube into place with a tiny smear of copper grease55555
(1 votes)
125 files on 7 page(s) 1