X9 Owners Club Gallery

Scooter related interest

Most viewed
Backrest_mk_2.jpg
Backrest_mk_2.jpgX9 Backrest brakets2211 viewsTo raise the supplied bum stop, making it a backrest. Use Sprung steel rather than mild, if available.
socket.jpg
socket.jpg2041 views
DSCF0005.JPG
DSCF0005.JPGClip engaged locking the two together1947 views
Radiator_and_front_wheel_fitted_28Medium29.JPG
Radiator_and_front_wheel_fitted_28Medium29.JPGFairinf Support1642 views
water_pump_28Medium29.JPG
water_pump_28Medium29.JPG1582 views
DCP01536.JPG
DCP01536.JPGBackplate mods1383 viewsCut the tangs as shown, and after reassembling the topbox rack, try for fit. You might have to cut a little bit more away at the top or bottom. The backplate is held in place by the two screws at the rear of the seat.
RH_side_of_battery.JPG
RH_side_of_battery.JPG1378 views
Battery_comp_RH.JPG
Battery_comp_RH.JPG1375 views
14042010410.jpg
14042010410.jpgfront view1315 views
14042010408.jpg
14042010408.jpg3 inch ram arm1282 views
pict0013.jpg
pict0013.jpgThe worst bit of wear but nothing serious1268 views
pict0033.jpg
pict0033.jpg1265 views
170120112800229.jpg
170120112800229.jpg1237 views
VLP1X9S-001_28Small29.jpg
VLP1X9S-001_28Small29.jpgMotad's stock photo of the X9 125 Venom system1214 viewsThis is the picture used in all of Motad's advertising for the X9 can
DCP01468.JPG
DCP01468.JPGRetaining Philips crosshead bolts1195 viewsRemove these, and throw them away, no longer needed.
DCP01465.JPG
DCP01465.JPGBolts hiding in hole.1155 viewsThese can be tricky to remove, a magnetic screwdriver can be useful.
GPS_mount_2.JPG
GPS_mount_2.JPG1153 views
Air_Sensor_Connector_28Medium29.JPG
Air_Sensor_Connector_28Medium29.JPGAir Sensor Connector1120 views
3575 files on 199 page(s) 1